QUICKSTART GUIDE
USB CONDENSER
MICROPHONE
WITH POP FILTER & STAND
KACONMICPHA
SAFETY & WARNINGS
- Lower the volume before moving the microphone as very loud feedback can occur when the top of the microphone is covered by hands or the microphone is moved near to the speaker.
- Take care not to let the microphone fall or suffer physical damage.
- Do not store the microphone in a hot or damp place.
INSTALLATION
- Connect the base to the stand.
- Hand-loosen the base using the dial on the back to adjust its clearance, then slide it over the installation surface and tighten it to secure. Use the small screw on the bottom to tighten further.
- Connect the top of the bracket to the plastic shock-proof frame.
- Use the large screw button of the bracket to adjust the bracket angle and use the small screw button on the frame to adjust the frame angle.
- Install the pop filter and sponge ball as shown below. Connect the audio cable and route it through the shock-proof stand.
- After the microphone is installed and connected, plug the audio cable to the sound card and connect the sound card to the computer – alternatively, the audio cable can be connected directly to the computer.
SPECIFICATIONS
| Polar pattern | Unidirectional |
| Frequency response | 20Hz-20kHz |
| Sensitivity | -34dB±2dB (0dB=1V/Pa at 1kHz) |
| Output impedance | 150 Ω ±30% (at 1kHz) |
| Load impedance | ≥1000 Ω |
| Equivalent noise level | 16dBA |
| Maximum SPL | 130dB (at 1kHz ≤ 1% T.H.D) |
| S/N Ratio | 78dB |
| Electrical current | 3mA |
IN THE BOX
| A. Shock-proof stand | B. Condenser microphone |
| C. USB sound card | D. Microphone holder |
| E. Audio line | F. Sponge ball |
| G. Pop filter | H. Base |
| I. Vibration control frame | |
Need more information?
This is a Quick Start Guide, and we hope that this has given you the assistance needed for a simple setup.
For the most up-to-date guide for your product, as well as any additional assistance you may require, head online to help.kogan.com
